Georgia Dubs
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Project starting and tips

Go down

Project starting and tips Empty Project starting and tips

Post by rpm750 on Mon May 28, 2012 9:40 pm

I'm always kickin it around on YouTube. So much good stuff out there as well as crap. Ran across this guy who is teaching metal working. Great video...

Check out some of his other videos.

This guys has a lot of other vids getting deeper into sheet metal shaping.

I'd love to intern in a shop just so I can learn on the right equipment and have the guidance. I wish I could change career paths but little to late now.
rpm750
rpm750
Dub God

Number of posts : 2258
Age : 56
Location : Out in the shop.
Registration date : 2008-11-11

http://forum.georgiadubs.com/

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum