slammpain edition

DOODLE BUGG wrote:the seats look awsome

Glad you like 'em. I'll see you up there on Friday night.

started notching the frame an had the back droped an the axels were hiting the frame but not for long as long as the fuel lines will sta out te grinder

We missed you up at BAP.

we hate it we didnot makeit but i did not hate missing the weather yall had glade yall were thinking of us just tring to get some work done around here

Darrell's bus looks great. you did a great job.

I never got to look at it up close, I want to know the tires sizes.

peregrine67 wrote:Darrell's bus looks great. you did a great job.

Which one was this bus?

Red Bus, stripes along the bottom, Porsche Phone Dial wheels.

I was so sick that I didn't have mine rolling to this one but with all the mud it wasn't so bad, other than I would of had higher ground to sleep on!

rpm750 wrote:Red Bus, stripes along the bottom, Porsche Phone Dial wheels.

I'll post a photo.

Doodle, you need to start a topic under the "Shops" section of the forums to show off your work.

rpm750 wrote:I never got to look at it up close, I want to know the tires sizes.

he was runing 215/60/15 on all four corners with thephone diles 2.5 narrowed beam an i click in the rear it looked an road awsome

peregrine67 wrote:

rpm750 wrote:Red Bus, stripes along the bottom, Porsche Phone Dial wheels.

I'll post a photo.

Doodle, you need to start a topic under the "Shops" section of the forums to show off your work.

ill think about that

I need to see some of that rear notching so Tim and I can cut mine while the motor is out!

holy crap man how low are you going, are you gonna raise the tranny?

LB Bedwell wrote:holy crap man how low are you going, are you gonna raise the tranny?

He said he wants to spark everywhere he goes.

I wanted to make sure I had enough so I want hit nothing I still have to do the drivers side an yEs I'm planing on doing a trans raise but just not right now I'm ready to ride again I'm probably going to be working on the aztec the rest of the week so it will be the week end befor sparks are flying again my gaol is to drive it to home grown show I'm thinking of pulling my frontend back out an do a 7 inch beam raise but we will see

i will give yall a tip next time you have to grind some metal were a mask im still blowing black buggers an smelling grinding dust when i breath but its going to look cool

DOODLE BUGG wrote:i will give yall a tip next time you have to grind some metal were a mask im still blowing black buggers an smelling grinding dust when i breath but its going to look cool

Dust mask and safety glasses, you only get 2 eyes and 2 lungs

2 eyes all ready dont work to good 2 lungs are allredy screewed up an dont weld with shorts on the other 2 things you have dont like flash burn from the welder or sun burn that might be why there is no baby buggs running around done messed up those 2

at least you have some cool cars!!!

finished the rear frame todat hooked back up the park brake all i have levt is to hook up the clutch an bleed the brakes hope to drive it tomorrow wiill see

drove it out the shop an i still havnt bleed yje brakes so i will have to do this this weekend i hope i will adjust down the front at that point an start on some tubs

picts?

well im going to go lower but i need to tub the front an im going to get some shorter tires also but this is it also need a new drag link mine is wore slap out